How To Clean Water Softener Salt Tank. The salt pellet level should be under the highest water level reached inside the water softener tank. When i disconnected the old one, i put all the salt from it in a box in my laundry room instead of disposing it.
There should be at least a six to seven inch gap from the top of the tank. The first method is to unplug the unit of water softener and then unscrew the bolt to remove the resin tank. Remove the salt plate, immerse it in cold water, and add dish detergent.
Table of Contents
Now, Carefully Install The Resin Tank Back To The Water Softener And Refill The Salt Levels Before Plugging It Back.
This water is needed to mix with the softener salt and form a brine solution, which flushes out the resin beads and replenishes them with a new batch of sodium ions. Put 5 gallons of clean water into the brine tank. Remove the loose salt pellets from the top with a plastic container or scoop of some kind.
Be Sure To Refer To Your Softener’s Manual To Confirm The Manufacturer Approves This Method.
Use the power washer to rinse the inside of the brine tank. Once you have the tank separated, you’ll want to make sure you remove any excess salt. Do not add too many salt pellets;
Choose The Right Cleaning Solution.
You can soak it in hot water to help remove salt. The salt pellet level should be under the highest water level reached inside the water softener tank. 1/4 teaspoon per gallon of water.
Be Sure The Floor Where The Brine Tank Sits Is Clear Of Debris.
Dump water out of the brine tank. This may require you to siphon or dump the water. Remove any salt at the bottom of the tank.
Using A Household Scrub Brush And A Mild Soapy Solution, Clean The Salt Plate.
Shut off the water supply When i disconnected the old one, i put all the salt from it in a box in my laundry room instead of disposing it. Lay the salt tank on its side and direct a brisk stream of water from your garden hose to its inside to rinse out all residue.